borislavgajic wrote:Grrrrrreat work man!!!!!!!!
one day all EHX tube pedals will be completed like this one
puretube could help us.... ......it is great for repair originals,and for information...
Job very well done. Expect regrettable complaits from copyright holders ... but... really,respect!
Have a nice day........it is a Tube zipper based wah (optical) with "alco Rakija" proximity controller
ATTENTION; WARNING: Remove above link to/drawing of illegally redistributed IP IMMEDIATELY!
So I controlled all the files, but I couldn´t find one, where I doubt that "borislavgajic" is the copyright owner. For this reason the claim of removing the files is not justified by any law.
But I renamed the thread and moved it to the correct section.
....it is a Tube zipper based wah (optical) with "alco Rakija" proximity controller
station wrote:If I get a chance to open up my Wiggler, and I'll try get a photo of the piggyback board. But, as you can see from Soul Sonic's photo earlier in the thread, it's connected by a few wires that hold it pretty close to the main board. Getting a decent picture of the trace side will be very difficult without desoldering.
lolbou wrote:Can't seem to find the transformer at Newsensor.com... Any tips?
Thanks for the good job here!
Analoggurru haven't made some pictures of that pedal ?
I'd try to take pics of the inside and solder side. I'm not really sure about desoldering wire, every time I modded an EHX product the PCB board trace fall appart. Plus, I may sell that pedal (need a cabinet) even if I'd love to keep it. So I'd see what I can do.
changing the LFO speed and make a bigger change with modes could be nice, also, maybe, increase the output level via the "volume" control . (and why not creating a really low drive setting to overdriven the valve )
sinner wrote:Dose anyone complied this build?
Himister, your layout is looking lovely as always Also BIG thanks to Boris and the rest for input, I'm getting erection to build it
.............................................no need to desolder wires... just make photo of component side,but nice photo...not from an angle....and if you can give us dimensions of piggy board .....and all other photos of that board are most welcome....I'd try to take pics of the inside and solder side. I'm not really sure about desoldering wire, every time I modded an EHX product the PCB board trace fall appart. Plus, I may sell that pedal (need a cabinet) even if I'd love to keep it. So I'd see what I can do.
Users browsing this forum: Google Feedfetcher, Majestic-12 [Bot], nickthemen and 11 guests