Dr Tony Balls wrote:1. is there a way to change the size of the strip board? if there is I couldnt figure it out.
Yes. Go to the menu: File -> Properties
Dr Tony Balls wrote:2. when I first opened it up and started using it, the components were all rather transparent. But when I reopened the app they were much more opaque (to a nice level where you could read the value but also see trace cuts underneath. i'm attaching the original too-transparent image.
In the bottom right side of the app there is a slider for component opacity
Dr Tony Balls wrote:3. could it be possible to automate the printing of a component list on the component side image export? Basically, i didnt see a way to print the image and understand what values all the components are.
After copy/paste the BOM (Bill of materials) is the first thing on the list.
Dr Tony Balls wrote:4. was there a trimmer option? i dont remember.
Not yet on the creation of layouts. However if you open an existing .diy layout trimmers will be displayed.
Dr Tony Balls wrote:Other than that i like it a lot!
Thanks!