tag to other part of the circuit..???

ballfire · Post by **ballfire** » 22 Apr 2011, 06:34

hello

can i tag somewhere in the circuit of a diy pedal my millenium bypass led indicator rather than on the dpdt switch? but the function still the same.. it will lit up in on mode.. it will turn off on the bypass mode?

any opinions,thank you..

Hides-His-Eyes · Post by **Hides-His-Eyes** » 22 Apr 2011, 09:13

Yes, you could put it on a separate bit of perf or on the main board of the effect or whatever; electronically they're essentially the same.

ballfire · Post by **ballfire** » 22 Apr 2011, 10:14

thank you sir for the reply but...

i mean like this..

: millneium.GIF (4.24 KiB) Viewed 769 times

good day..

Hides-His-Eyes · Post by **Hides-His-Eyes** » 22 Apr 2011, 10:32

You need it going via the switch somehow; the idea is that the "control" connection of the millenium bypass connects to nothing ("floating") when the pedal is on, but connects to the output of the circuit when the pedal is off.

Is there a reason you can't connect it to the switch? There might be another solution to your problem.

ballfire · Post by **ballfire** » 22 Apr 2011, 11:11

good day

yes you're right there's a reason..it making a "thud" noise when i engaged my millenium bypass in the dpdt stomp switch its very audible..

so i just wondering is there a possibility to connect it to other part of the circuit?but same funtionality..

thanks for the reply..

Hides-His-Eyes · Post by **Hides-His-Eyes** » 22 Apr 2011, 11:24

That's a common issue but there are many causes.

Try searching for "millenium bypass popping" on aron's forum (DIYstompboxes) where the developer of the circuit, RG Keen, posts a lot.

ballfire · Post by **ballfire** » 23 Apr 2011, 06:10

thank you sir..