I just built up a BB-1 using the V1 layout found here: https://3.bp.blogspot.com/-Bj8twAFTYCU/T00Cawgr1BI/AAAAAAAAA5A/2YtalNYraJs/s1600/Marshall+Bluesbreaker.png Everything works, voltages to the chip pins are all correct, diodes are 4148's showing .63v forward voltage when tested in circuit. The on...

Yep, the range control.

I figured this as well but it's actually been done with a DPDT:

https://images.reverb.com/image/upload/ ... uybvii.jpg

Complicated switch wiring always throws me for a loop for some reason so I'm hoping you guys could help me out. I have a 10 pin 2P3T slide switch that I would like to replace with a DPDT toggle. Using the schematic attached, how would I go about wiring the DPDT to the same effect? I copied this conn...

There's no published schematic for the french toast. I was thinking there might be a difference in the switch operation since I followed the same instructions found in this thread, yet mine is porking backwards: https://www.diystompboxes.com/smfforum/index.php?topic=68453.0 EDIT: Well, found my prob...

I am rehousing a Danelectro french toast fuzz (Foxx TM) and added an led via switching ground off terminal 13 of the 4013 chip, works fine except the LED is flipped, when I turn off the effect the LED comes on. I suspect this comes down to the switch I used: https://lovemyswitches.com/pro-grade-spst...

Looking for a few TDA7052B chips if anyone has some to sell. Thanks!

Thanks! I'll give it a shot.

Thanks! I caught that when I traced my original.

Hey, I'm working on building a D&S II clone and noticed something I'd like to fix. I have the schematic below, I actually own a real one of these and the original does the same thing. When the gain pot is maxed the circuit gets super trebly, but if you back off just a bit, say 5% from max gain t...

Guitar only

Thanks!

I recently built a Cephid chorus from PedalPCB (CE-2 clone). Works great and all component values were tested before building to make sure everything was in spec. I compared it to a Danelectro Cool Cat 18v (cs-505 clone) and the cool cat had a bit more bass response which I tend to favor. Does anyon...

Zombie resurrection time! I just built the three-knob version of this and had two issues I wanted to see if someone could chime in on: 1) I would like to get more overall gain out of this, especially with the boost side off. What resistor should I adjust to give me more gain for both channels? 2) Th...

anyone?

Does anyone have updated guts pics? The links are all dead. The pcb board that the pots connect to broke on mine and I need a guide to direct wire the pots to the ribbons can anyone help?

Thanks