I couldn't enhance the picture enough to get an idea about how the bass pot works. Any clues?

What's the purpose of those parallel caps? C12 & c13? I'm asking because if you connect c12 to accent 1 and leave c13 as is...it works as a high presence filter. Did someone try this?

Thanks a lot bugg

And still retains its crown. No tracing yet...

Thank you so much

Hello. Is there any printable pcb layout for this? Thanks.

Ahh...ok. i was trying to get 2 independent 9volts outputs as in an isolated supply. Thought would be possible using a similar approach but using the coil tap as a common and rectifying the outer leads...in a 9+9 tranny...

Hi. I've tried to post in the power section but seems closed. Can i have 2 +volts outputs out of a split transformer using 2 bridge rectifiers and a common ground?

Link to the original demo record...

Ok...solved. the 100p that was supposed to be a multilayer...was an inductor!

There is a minimum of audio. When i pluck hard comp led works as supposed...signal gets clamped and comp level does work also as expected...clamping hard when ccw...

Thanks plush. Strange is that compressor is working ok. I have audio probe til one leg of r76. Then it drops to almost nothing . If i take the comp ics out...still the same.

Hi. Just finished this project and i am having problems with r76. Before it, i have audio probe and tested the 4.40 ac volts as per calibration. Right after it, audio is almost lost and ac volts drops down to few millivolts. Any clues?

Happy new year! And thank you Baja for being the engine of the forum by bringing new stuff to the new year!

Wow this one wins the prize for longest time without reversing in fsb!

Wow this is definitely useful. Will try it. Thanks a lot?!

Hi. Can i take the bulb and ldr out of the circuit and leave it open?

+1 on decoding this one...

do you guys know why they've chosen a 220k resistor inthe cathode follower stage?. it seems pretty high. the original had 22k in there.
i also think the last resistor is 10k. but it shouldn't be calculated as an isolated part...because it's part of a 2 pole low pass filter formed by r12,13 and c9,10.

bumping an old thread to see if someone has more info...