I did pcb and it works, but debounce time is killing me. Also I wish there was a PC message that turns off all loops at once. from the Build Doc Switch Debouncing Time In the code found in the .zip file, the switch debounce time is perhaps a little generous. I have found that this results in needin...

I did a little more development on it, but it's still mostly schematics and pseudo code. I should revisit it. I don't think it should be overly hard, I just keep getting distracted 😆 Any chance for revision? :) :) I did pcb and it works, but debounce time is killing me. Also I wish there was a PC m...

Hi everyone, I just found few pics of insides of TBM95 cry baby and I managed to read the most of values. Since it is same pcb as mine ZW45 here are values of ZW45 and TBM95 presented throught pcb part names: TM95 ZW45 R2 1k 1k C4 220u 220u C8 220n 220n R7 470k 470k R17 jumper jumper R8 10k 10k C5 1...

Thanks for posting. Probably right side is Klon and left Bluesbraker..

megatrav wrote: ↑11 Oct 2020, 18:21 There is a thread where someone traced their Kingsley Page. I would bet it has the same power supply in it?

It is same, but from pictures in that thread that smps circuit is smd, so it is much harder to trace then through hole part pcb..

Thanks for trying. Can you read numbers on the yellow capacitor?

megatrav wrote: ↑11 Oct 2020, 14:47 Honestly, it’s really hard to get better pics. I would have to de-solder wires if I wanted to get clearer pics

Easiest way is to unscrew two screws that are holding pcb, that would give you enough space to take pics..

Here is PSU schematic based on guesses and readable values of components, but without 6v3 regulator.

Thanks for pics. Any chance for more pics so we can trace power supply pcb? Could you take pics of bottom side of power supply pcb, also we need values of the yellow multilayer cap, el.cap behind the irf730 and the value of the el.cap close to 6v3 regulator.

plush wrote:Hi!

I can verify V1nce69's work.

Would you share your layout?
Cheers

Hi guys, any infos about this pedal?

There is 10M grid resistor to the ground. Also I tried 68k grid resistor and I didn't here big change in the sound.

I've used 150n caps for cathodes.. I tested it through plexi style clean.

Any builds?!? I build one in my test box and it sounds really good. There is little bit of oscillation when the tube is close to smps supply (extreme settings gain and tone). Also wiring is spagetti type, so that could introduce oscillation too, but I used shielded cable for input/output and fx in/o...

Yesterday I was tracing from pics and I draw exactly the same layout/schematic, except I think gain pin 2 should be grounded not after 220k. From other kingsley pedals maybe cathode bypass caps are 150n? Also gain should be A500k.

Also kingsley uses 6v3 heaters..

Few years ago I had same problem with the pinnacle build, so so I increased input resistor. In your case R2, if I remember correctly I changed it with the 33k

Hi guys, if anyone needs pcb for taxi drive I have spares that I won't build.. 7$ shipped

Hi guys, does anyone have any infos on this pedal. I have attached pics that culd be found online. So far it looks very simple, I think input and output buffers, driver for reverb tank and mixer circuit.

Cheers

Then check if the effect is switched when engaged..

Check if lamp is working under the mini metal box..