Ron-

Thanks for the scheme! Does the Farfisa sound any different from the Vox?

does this one use the 2n2646 like the Vox?

either a Clip or a Fastener. I can't recall which, but I bet these guys know:
http://www.clipsandfasteners.com/Clips_ ... g_s/79.htm

For future generations... the vero on page two has an error:
R12 should be 56k not 56R.

I bought a set from sunpec. they were just fine, albeit with the thin leads, and a few weird useless values.

However, the sudden uptick in the amount of Rolex / Viagra spam appearing in my inbox was less than fine.... your mileage may vary.

killing some time at work... so here is an overlay of the components and traces, along with the board shot & component shot that I used to make the composite.

Holy crap!

Impressive....

KindaFuzzy wrote:Pedals always sound better when you tilt the board.

Promotes asymmetrical clipping cuz the electrons kinda flop over to one side.

You have tempted the stompbox gods by boxing the effect up without the requisite number of curse words. Unbox it and burn at least one carbon comp resistor on the mojo altar. It should work then. Also... Bias to the collector as johnnyg said. And is the 5n cap connected correctly? I couldn't tell fr...

I have been contemplating which version of the muff I should build for myself.... I appreciate you making up my mind.

This looks great.

that is very, very handsome.

Mcm electronics has the 2sb176

http://www.mcmelectronics.com/product/2SB176

A quick question on the Russian 322.... it is one that has the pinout with the 4th ground leg. Is it just my imagination, or did I read somewhere on here that the 4th leg can just be cut off and/or ignored? I might have dreamt it because I can't find that post anywhere... I have a fuzz with a 322 in...

Bump

I can't quite tell from the dark photo, but it looks like there may be some solder bridges between rows 2 & 3 and rows 3 & 4.

Did you use the continuity checker on your DMM?

Aaaaargh!!!!

I really want that.

That looks fantastic. The Green Bomb I built has issues and seeing this makes me want to dig it out for some debugging...

And what kind of enclosure is that? It looks nice and roomy.

Great work, as always.

sinner wrote:Does anybody have the PCB version of this? The reason I'm asking is - if not, I'll do that

madbean
http://www.madbeanpedals.com/

http://www.switchedonaustin.com/effects ... nther.html

(and no, I don't work there...)