You gotta be kidding me...

The pedal works perfectly in 8 second mode. However, when I switch to 2 or 1/2, the effect doesn't work. When it kicks in, it basically doubles the signal overtop of the input, i.e. Just makes the sound a little warmer. There are no trails, echos, or repeats. The delay controls don't seem to change anything. The controls all work perfectly in 8 second mode however. I've recapped and swapped ICs. I get the voltages on the 4066 when sliding the selector switch. Interestingly, if I jump pins 3&4...

Anybody have a schematic for the Digitech PDS 8000? I have one that produces no effect and the infinite loop is locked on. I will at times get a digital squeal when the effect is engaged (and the infinite loop is too obviously) until I go back to bypass.

Hi guys, I'm repairing this amp but actually I cannot find a solution.

Clean channel and Power Amp works correctly.
Boost channel works but has a really low volume.

In attachments you will find the schematics.

I checked the tube section and everything is fine. Autotransformer works.

Voltages at tubes are:

1 - 181V
2 - 110V
3 - 110V
4 - 5,8V
5 - 5,7V
6 - 110V
7 - 0
8 - 0,675V
9 - 0

D3 Cathode - 266V

IC3 and IC5 are working because the switch is works correctly. I don't have replacement at...

Recently I built an MXR GT-OD.

W20K is recommended for the tone pot, but I didn't have it in stock, so I made it with B25K.
I know that it is used as a replacement for the W20K in many TS pedals, and I also have a few TS pedals made with the B25K.

However, make my GT-OD with B25K, the tone was too dark when the tone pot was set to 12 o'clock.
I looked for other errors, but there were no special problems, so I purchased a W20K and replaced it.

There has been a big change. It gave me a...

It’s been a couple of years since I’ve made the first Pelota delay: from the very name, it was a circuit inspired by a few popular PT2399 delays, such as the Rebote series, the Deep Blue Delay, and many others that aren’t that different to be worth mentioning.

Even then, with my more limited experience and knowledge, I knew I could try to do better, starting from the awful, noisy, high resistance inverting input stage you find in the vast majority of them that makes you wonder who did it first...

Hello,
I haven't seen anyone do this yet, so I thought I'd get one and trace it! Please let me know if there's anything that you see that looks obnoxiously wrong, or if there's anything that you think I may have missed.

No, the VD does not stand for venereal disease . It stands for vintage delay .

There's a Cool Audio V3205 under the hood. The clock chip is marked CD3102GP, which is NOT made by Cool Audio. Does anyone recognize the manufacturer logo on it?

Bottom side has a shit-ton of SMD, as expected.

I managed to eek out a bit more than 300ms out of it by dicking with clock trimmer. But it's a very tight range that sounds good (to me).

For the money, it's a pretty good short analog delay. The filtering...