Guyatone - TD-X Tube Echo (Flip Series) [schematic]
Information
- Posts: 33
- Joined: 19 Nov 2007, 19:37
- Completed builds: BSIAB2, Zen Drive, Geoffrey Teese Picture wah, Catalinbread Dirty Little Secret, Octavia, A LOT OF FUZZ PEDALS, Neovibe, Barber Tone Press-alike, few guitar amps (Soldano SLO 100, Dumble ODS, Fender Super Reverb, Marshall JTM-45, Fender Champ)
- Location: Lahti, Finland
- Has thanked: 5 times
- Been thanked: 1 time
Hi!
I promised to put the schematic here already some days ago, but didn´t have enough time. So, here it is... if there is a thread about this pedal, moderators could move the schematic there or something.
I promised to put the schematic here already some days ago, but didn´t have enough time. So, here it is... if there is a thread about this pedal, moderators could move the schematic there or something.
- Attachments
-
- TD-X_EPK-466.pdf
- (1.19 MiB) Downloaded 1002 times
Hi, I've just received this pedal, used... It obviously has a problem, the echo sound is clipping to the extreme... I don't mean the slight distorting of the delay signal that is normal, but simply clipping too loud...
When analog knob is anywhere over 0 it is distorting, but even "Tape" knob clips too much on the low E string...
What is most common for this problem? Faulty tube or should I return it today? I've tried with 2 different DC12V adaptors with the same clipping result... Please help, this pedal is too expensive too be this lousy sounding!
When analog knob is anywhere over 0 it is distorting, but even "Tape" knob clips too much on the low E string...
What is most common for this problem? Faulty tube or should I return it today? I've tried with 2 different DC12V adaptors with the same clipping result... Please help, this pedal is too expensive too be this lousy sounding!
Nevermind, it wasn't the pedal it was my 10W solid state amp... Played it on three other amps, tube amps, with no problem...Marko9801 wrote:Hi, I've just received this pedal, used... It obviously has a problem, the echo sound is clipping to the extreme... I don't mean the slight distorting of the delay signal that is normal, but simply clipping too loud...
When analog knob is anywhere over 0 it is distorting, but even "Tape" knob clips too much on the low E string...
What is most common for this problem? Faulty tube or should I return it today? I've tried with 2 different DC12V adaptors with the same clipping result... Please help, this pedal is too expensive too be this lousy sounding!
- Fredenando
- Breadboard Brother
- Fredenando
- Breadboard Brother
Information
- Posts: 20
- Joined: 29 Sep 2011, 05:26
i love this pedal, but I get the repeats bleeding through to the bypassed clean signal when they're oscillating, and the indicated led starts to light up a bit. Any thoughts?
Information
- Posts: 20
- Joined: 29 Sep 2011, 05:26
The schem and layout dont seem have component values. Also, does anyone know what the delay chip is in this thing (and any other delays that might use it)?
Does anyone out there have a schematic for this pedal ? Someone used the wrong power supply on mine and fried a chip or a transistor . A schematic for this pedal would be really help in troubleshooting this old effector . Thanks for your time !