REAGUN DISTORTION [schematic]
- Manfred
- Tube Twister
Information
- Posts: 1937
- Joined: 04 Apr 2009, 23:42
- Has thanked: 1672 times
- Been thanked: 1344 times
While cleaning up I found this incomplete Reagun Distortion that I bought years ago.
Anyway, now I have traced it.
Here the PCB layout and the schematic, some measurements come later.
This is the same PCB as the REAGUN Overdrive but partly with other, omitted and additional components
Ready to print PDF-Files: SprintLayout 6.0 File:
Anyway, now I have traced it.
Here the PCB layout and the schematic, some measurements come later.
This is the same PCB as the REAGUN Overdrive but partly with other, omitted and additional components
Ready to print PDF-Files: SprintLayout 6.0 File:
- Manfred
- Tube Twister
Information
- Posts: 1937
- Joined: 04 Apr 2009, 23:42
- Has thanked: 1672 times
- Been thanked: 1344 times
Ups! I forgot the pictures in my last post.While cleaning up I found this incomplete Reagun Distortion that I bought years ago.
- Manfred
- Tube Twister
Information
- Posts: 1937
- Joined: 04 Apr 2009, 23:42
- Has thanked: 1672 times
- Been thanked: 1344 times
During the repair I found an error in the schematic, the resistance between terminal 5 of the OP-amp and the 4.5 volt point has a value of 470 Kiloohm and not 22 Kiloohm.
- george giblet
- Resistor Ronker
The 10n on the switch probably connects to the 1k and ground. The 2x220p connects to the 1k + 10n + 1M point.
- Manfred
- Tube Twister
Information
- Posts: 1937
- Joined: 04 Apr 2009, 23:42
- Has thanked: 1672 times
- Been thanked: 1344 times
Hi George,
Thanks for looking closely you are right.
Thanks for looking closely you are right.
- mirosol
- Resistor Ronker
And a stripboard layout for this one too.
+m
+m
http://tagboardeffects.blogspot.com/
http://mirosol.kapsi.fi/
"No such thing as innocence" -Iron Chic
http://mirosol.kapsi.fi/
"No such thing as innocence" -Iron Chic
- Manfred
- Tube Twister
Information
- Posts: 1937
- Joined: 04 Apr 2009, 23:42
- Has thanked: 1672 times
- Been thanked: 1344 times
Georg Giblet recently found a fault in the input circuitry of the Reagun overdrive, thanks again.
While tracing the layout I found two more faults and have corrected the schematic.
The input circuit part of the Reagun Distortion is identical to that of the Overdrive and was also wrong in its schematic and had to correct it.
I am sorry.
Corrected schematic:
While tracing the layout I found two more faults and have corrected the schematic.
The input circuit part of the Reagun Distortion is identical to that of the Overdrive and was also wrong in its schematic and had to correct it.
I am sorry.
Corrected schematic: