Page 5 of 5

Re: BAJA JVM overdrive pedal 040218

Posted: 19 Nov 2020, 09:10
by GeoffroyLux
salin3 wrote: 07 Nov 2020, 17:38
Hi,

I can't see where the SW 1 - 11 goes, I don't find where the OUT is on the layout.
Can you help me figure it out ?

Thanks !!!



Sw1-11 is THE output, so the lead from Sw1-11 goes directly to the output jack ;)

Re: BAJA JVM overdrive pedal 040218

Posted: 19 Nov 2020, 11:28
by salin3
Ho that was so obvious ... thanks for your reply ! Hope the pedal will rock now !

Re: BAJA JVM overdrive pedal 040218

Posted: 19 Nov 2020, 13:18
by GeoffroyLux
Let me know if yours is free of squeal ;)

Re: BAJA JVM overdrive pedal 040218

Posted: 22 Nov 2020, 08:36
by salin3
I don't have that kind of squeal / buzz , mine is working ok.

Re: BAJA JVM overdrive pedal 040218

Posted: 22 Nov 2020, 08:38
by GeoffroyLux
Great !
That's mean I have to debugging mine ^_^

Re: BAJA JVM overdrive pedal 040218

Posted: 27 Nov 2020, 13:42
by salin3
I've made the pedal and it sounds great.
Now I would like to add a tone stack but I don't know how to wire it as I've made a version with 2 separate volumes ( see layout) and I'd like to have only one EQ for both channels.
Someone could help me ? Thanks !

Re: BAJA JVM overdrive pedal 040218

Posted: 07 Dec 2020, 12:12
by Willypp
Hook the input of the eq to switch 1 - 10 on the board. Hook the eq output to switch 1 -10 on the switch itself.

Re: BAJA JVM overdrive pedal 040218

Posted: 14 Dec 2020, 08:57
by salin3
Thanks for the replie !
I tried this but it doesn't work.
The pedal is working but the pots of the EQ don't react except the trimmer working like a volume.
Maybe a bad pot ?
Or someone would have a clue ?