MN3002 to TDA1022P conversion PCB
- johnk
- Resistor Ronker
i'm looking to etch a PCB that would enable the use of a TDA1022P (16 pin) in place of an MN3002 (14 pin) but i don't know how the pinouts would have to be rearranged to make them match. i saw one available for purchase and was only $2.75 but the shipping was $30 from overseas. ( https://www.aaranis.com/mn3002-to-tda10 ... 374290.htm ) does anyone here know what the pinout conversion would be? it would be greatly appreciated! thanks in advance!
- deltafred
- Opamp Operator
John. What are you building that uses a TDA1022/MN3002?
I've had a TDA1022 in my spares box for decades that is looking for a project.
I've had a TDA1022 in my spares box for decades that is looking for a project.
Politics is the art of so plucking the goose as to obtain the most feathers with the least squawking. - R.G. 2011
Jeez, she's an ugly bastard, she makes my socks hurt. I hope it's no ones missus here. - Ice-9 2012
Jeez, she's an ugly bastard, she makes my socks hurt. I hope it's no ones missus here. - Ice-9 2012
- deltafred
- Opamp Operator
Thanks. I thought that you might have had a new project in mind.
Politics is the art of so plucking the goose as to obtain the most feathers with the least squawking. - R.G. 2011
Jeez, she's an ugly bastard, she makes my socks hurt. I hope it's no ones missus here. - Ice-9 2012
Jeez, she's an ugly bastard, she makes my socks hurt. I hope it's no ones missus here. - Ice-9 2012