Component placing problem because of too much space!

Digital tools for electronic work: software for pcb design, schematic drawing, circuit simulation, parts inventory tools, ...
Post Reply
User avatar
meffcio
Solder Soldier
Posts: 189
Joined: 25 Mar 2009, 19:31
Has thanked: 5 times
Been thanked: 14 times

Post by meffcio »

Hey everyone.
I am slowly digging into PCB designing, and now I've encountered a silly problem.. I'm designing a no offboard wiring PCB for a Ruby amp with the bassman mods, with the board size suited for a particular box. The fact is I have too much space there, therefore I don't really know what configuration will work the best. If I were limited by space I think there would be no problem. ;p
So here's my layout. It's kinda done, but I'm not sure about it.
rubybassman.png
What should I change?

[EDIT]
Ooops, just saw I connected the DC jack wrong way. It's now ok on my layout, but not the one shown here.

Post Reply