[Eagle] PCB connector
Hi there!
I'm looking for the correct connector in the Eagle's library. I want to mount this, I think that the pass between each pin is 0,25 cm (like the title of the item suggest) but I can't find anything like that in my libraries.
Any tip is welcome!
I'm looking for the correct connector in the Eagle's library. I want to mount this, I think that the pass between each pin is 0,25 cm (like the title of the item suggest) but I can't find anything like that in my libraries.
Any tip is welcome!
- marshmellow
- Cap Cooler
Go through the con* libraries, you will find several connectors that fit your footprint.
I'm not at home right now and don't have Eagle installed here,
I'll take a look later to see what I normally use.
I'm not at home right now and don't have Eagle installed here,
I'll take a look later to see what I normally use.
Thanks, I knew it was in the con* libraries, where I just searched, but I couldn't find...marshmellow wrote:Go through the con* libraries, you will find several connectors that fit your footprint.
I'm not at home right now and don't have Eagle installed here,
I'll take a look later to see what I normally use.
Information
Tom1884 wrote:I think this size it's ok. But it doesn't work well:madbean wrote:Here's one with a 6-pin. See if it works for you.
1) I can't wire the pin
2) overall, I can't separate each pin on the schematic, I can only move the entire piece
1) Wire to the little piece that juts out from the circle.
2) Fixed
It's ok, it works now, thank you very much!madbean wrote:1) Wire to the little piece that juts out from the circle.Tom1884 wrote:I think this size it's ok. But it doesn't work well:madbean wrote:Here's one with a 6-pin. See if it works for you.
1) I can't wire the pin
2) overall, I can't separate each pin on the schematic, I can only move the entire piece
2) Fixed