L7660SCPA Diode Protection

Frequently asked questions regarding powering your pedal.
Post Reply
User avatar
boblob
Breadboard Brother
Information
Posts: 85
Joined: 27 May 2010, 20:53
Completed builds: I've built clones of these:
Si and Ge Fuzz Face
Ampeg Scrambler
Vox Repeat Percussion
Big Muff triangle
Mosrite Fuzz Rite
Maestro Super Fuzz
MXR Distortion +
Rebote Digital Delay
Shin-Ei Companion
Has thanked: 5 times
Been thanked: 10 times

Post by boblob »

Hello.

I've been using the L7660 for bipolar power for a while. Was about to order some when I noticed the company had issued an advisory to a change in the data sheet. The datasheet now recommends adding a Schottky diode between the -ve output and ground to prevent latch-up. It says to so this if the rise rate is > 2V/us.

I've one in my Gristleizer and am wondering if I need to do that - I don't really know how to estimate the rise rate.

I also noticed that it recommends to add a 1N4148 from the -ve pin to ground to prevent latch-up

I know charge pumps can be fragile beasts, so this would be nice to know!

Post Reply