Page 2 of 2

Re: Where can I get PCB's made????

Posted: 25 Apr 2011, 16:09
by madbean
DaveKerr wrote:It's about time I get off my ass and learn how to use Eagle - I've been half-assing mods, like hanging voltage invertor vero boards off DC jacks and stuffing multiple leads into oversized holes for heat compensation diodes on Fuzz Face boards. Why not go from breadboard straight to something you're not embarrassed to take the cover off?

Shameless plug: you could use this project I posted over the weekend to try your hand at a double sided layout: https://www.freestompboxes.org/viewtopic ... 13&t=12918

The hard stuff is already done....just create a new layout for a double sided board :)

Re: Where can I get PCB's made????

Posted: 05 May 2011, 00:19
by jsrfo
OK, can't find any freeware out there that converts Express PCB to something Eagle can use, gerbers, etc. Anyone out there know of any software or anyone that converts for a fee? Laen cannot use Express PCB files. Crap...

Re: Where can I get PCB's made????

Posted: 05 May 2011, 11:00
by Hides-His-Eyes
There's no one click tool. ExpressPCB do this very deliberately.