Ross Failure/

Frequent questions about dead or faulty pedals. Whether you repair, mod or build pedals, debugging is important. Threads about general debugging problems irrespective of the circuit involved...

Ross Failure/

Postby gsm78 » 02 Nov 2009, 05:44

Hi everyone,
Total diy stompbox nOOb here.
I have just (kind of) finished a tonepad Ross Phaser which sounds awesome except for one little issue.
There is a pop/tick/trip/skip at the start of every phase cycle. The higher the rate the faster the pops, lower the rate slower the pops.
I have rigged the PCB out of the enclosure to ensure the problem is not due to any of the off board gear, still pooping.
I have checked all my solders which look okay and I have swapped around the 3 matching ICs, no help.
Im picking a dodgy Cap but thats only a guess.

Any ideas?
Posts: 1
Joined: 02 Nov 2009, 05:34
Has thanked: 0 time
Have thanks: 0 time

Return to Debugging

Who is online

Users browsing this forum: No registered users and 2 guests