Hermida Mosferatu [traced]
- reneshelle
- Solder Soldier
YES! Nothing beats posting the exactly same as the post right above
- IvIark
- Tube Twister
Information
Vero layouts for the 3 and 4 knob versions based on kusi's schematic. Is the voice control on the 4 knob right kusi, or would it be like the Zendrive?
3 knob
4 knob
3 knob
4 knob
"If anyone is a 'genius' for putting jacks in such a pedal in the only spot where they could physically fit, then I assume I too am a genius for correctly inserting my legs into my pants this morning." - candletears7 - TGP
- IvIark
- Tube Twister
Information
- sinner
- Old Solderhand
Information
- Posts: 4709
- Joined: 06 Nov 2008, 17:16
- Location: ...no more
- Has thanked: 1031 times
- Been thanked: 909 times
Slightly off topic... I've just been on your blog, you're like a machine!
- IvIark
- Tube Twister
Information
Ha ha, one of my new years resolutions was to put a bit more effort in to do some new layouts. I may have gone a bit overboard though!
"If anyone is a 'genius' for putting jacks in such a pedal in the only spot where they could physically fit, then I assume I too am a genius for correctly inserting my legs into my pants this morning." - candletears7 - TGP
- sinner
- Old Solderhand
Information
- Posts: 4709
- Joined: 06 Nov 2008, 17:16
- Location: ...no more
- Has thanked: 1031 times
- Been thanked: 909 times
This is the spirit I like
Information
- Posts: 1
- Joined: 22 Feb 2013, 09:15
I'm building off of this schematic from Mark's blog at:
http://tagboardeffects.blogspot.com/201 ... eratu.html
For the two capacitors labeled 470n, I bought .47uF Tantalum caps, which obviously are polarized. I can't figure out which way to put them or if it's even always possible to use a polarized cap in place of a non-polarized one.
Can anyone tell me how to understand from a schematic which way the polarity of a cap should be?
http://tagboardeffects.blogspot.com/201 ... eratu.html
For the two capacitors labeled 470n, I bought .47uF Tantalum caps, which obviously are polarized. I can't figure out which way to put them or if it's even always possible to use a polarized cap in place of a non-polarized one.
Can anyone tell me how to understand from a schematic which way the polarity of a cap should be?
Information
- Posts: 2
- Joined: 09 Jul 2018, 13:12
Schemat.
- Attachments
-
- MOSFERATU.gif (10.24 KiB) Viewed 1371 times
- modman
- a d m i n
Information
- Posts: 4897
- Joined: 19 Jun 2007, 16:57
- Has thanked: 4410 times
- Been thanked: 2139 times
found online
Please, support freestompboxes.org on Patreon for just 1 pcb per year! Or donate directly through PayPal