Menatone Foxy Brown

General documentation, gut shot, schematic links, ongoing circuit tracing, deep thoughts ... all about boutique stompboxes.
Post Reply
User avatar
Chugs
Resistor Ronker
Information
Posts: 278
Joined: 16 May 2009, 09:47
Has thanked: 63 times
Been thanked: 45 times

Post by Chugs »

Volume 250KA
Gain 500KA
Tone 500KA
Sag 1KB
Attachments
CIMG1854.jpg
CIMG1854.jpg (48.72 KiB) Viewed 1875 times
CIMG1856.jpg
CIMG1856.jpg (60.01 KiB) Viewed 1875 times
CIMG1859.jpg
CIMG1859.jpg (53.16 KiB) Viewed 1875 times
CIMG1861.jpg
CIMG1861.jpg (54.16 KiB) Viewed 1875 times

User avatar
Steven_M
Resistor Ronker
Information
Posts: 386
Joined: 06 Jul 2009, 19:50
Has thanked: 59 times
Been thanked: 35 times

Post by Steven_M »

HOLY BIG TRACES!!!!

That one jaunty angled film cap is bugging me a little.

User avatar
Chugs
Resistor Ronker
Information
Posts: 278
Joined: 16 May 2009, 09:47
Has thanked: 63 times
Been thanked: 45 times

Post by Chugs »

How do you feel about the bent over electro? :lol:

Forgot to mention that the fets are J201

User avatar
Steven_M
Resistor Ronker
Information
Posts: 386
Joined: 06 Jul 2009, 19:50
Has thanked: 59 times
Been thanked: 35 times

Post by Steven_M »

Chugs wrote:How do you feel about the bent over electro? :lol:

Forgot to mention that the fets are J201
Is there a space constraint? Would the cap not fit in the box if it was upright?

I just checked google maps, those traces can be seen on google street view if you leave one outside your house. The only pedal that can be traced from space!

User avatar
Chugs
Resistor Ronker
Information
Posts: 278
Joined: 16 May 2009, 09:47
Has thanked: 63 times
Been thanked: 45 times

Post by Chugs »

Maybe the Shuttle crew can take care of this one then!

The electro is bent over so that it fits under one of the jacks.

User avatar
Chugs
Resistor Ronker
Information
Posts: 278
Joined: 16 May 2009, 09:47
Has thanked: 63 times
Been thanked: 45 times

Post by Chugs »

My first trace. I haven't had time to redraw on the computer yet.

Double sided board with, to my mind, a convoluted layout. Parts values were marked on the board but were different in a number of places. One position marked 100K had a 0.056f cap instead. All positions marked 1.5K were 1.8K. There was a spot for a 220K resistor to connect across lugs 1 and 3 of the volume pot but this was not fitted.
Attachments
Menatone Schematic.jpg

Post Reply