freestompboxes.org

Today I got this one to look at. This is version 1.Tracing was not difficult. Only one opamp is used for both sides {RC4580DD). Voltage dividing ( Vreff) is shared by both sides. Clear red leds are used. All caps are Panasonic film caps except the 47pF cap and the electrolytics in the divider-circuit. In the overdrive-section is a three-way on-of-on toggleswitch is used for bass. All resistors are metal-film. I don't have a good program for drawing schematics so i had to scribble some on the images .I hope it is clear enough. I didn't draw the switching . It is standard true bypass switching.

Hey guys, here I transcripted the layout, correct please if you see something wrong, cause I'm gonna prepare the PCBs tomorrow

sego91 wrote:Hey guys, here I transcripted the layout, correct please if you see something wrong, cause I'm gonna prepare the PCBs tomorrow

[ Image ]

Looks right, but I *think* r16 and r7 were 1k resistors, not 10k. I thought we had used independent voltage dividers as well, but maybe not on this version. It's been 8 years ago or thereabout, so I could be wrong. But yes, it's a fairly simple circuit. Have fun with it, I just ask you don't violate registered trademark and sell it as a Wampler or Hot Wired or similar derivative.

Another gut shot...

sego91 wrote:Hey guys, here I transcripted the layout, correct please if you see something wrong, cause I'm gonna prepare the PCBs tomorrow

[ Image ]

Did you ever do PCBs for this circuit? If so, do you have any available?

Cybercow
(moo)