BAJA JVM overdrive pedal 040218

GeoffroyLux · Post by **GeoffroyLux** » 19 Nov 2020, 09:10

salin3 wrote: ↑07 Nov 2020, 17:38
Hi,

I can't see where the SW 1 - 11 goes, I don't find where the OUT is on the layout.
Can you help me figure it out ?

Thanks !!!

Sw1-11 is THE output, so the lead from Sw1-11 goes directly to the output jack

salin3 · Post by **salin3** » 19 Nov 2020, 11:28

Ho that was so obvious ... thanks for your reply ! Hope the pedal will rock now !

GeoffroyLux · Post by **GeoffroyLux** » 19 Nov 2020, 13:18

Let me know if yours is free of squeal

salin3 · Post by **salin3** » 22 Nov 2020, 08:36

I don't have that kind of squeal / buzz , mine is working ok.

GeoffroyLux · Post by **GeoffroyLux** » 22 Nov 2020, 08:38

Great !
That's mean I have to debugging mine ^_^

salin3 · Post by **salin3** » 27 Nov 2020, 13:42

I've made the pedal and it sounds great.
Now I would like to add a tone stack but I don't know how to wire it as I've made a version with 2 separate volumes ( see layout) and I'd like to have only one EQ for both channels.
Someone could help me ? Thanks !

Willypp · Post by **Willypp** » 07 Dec 2020, 12:12

Hook the input of the eq to switch 1 - 10 on the board. Hook the eq output to switch 1 -10 on the switch itself.

salin3 · Post by **salin3** » 14 Dec 2020, 08:57

Thanks for the replie !
I tried this but it doesn't work.
The pedal is working but the pots of the EQ don't react except the trimmer working like a volume.
Maybe a bad pot ?
Or someone would have a clue ?

BAJA JVM overdrive pedal 040218 [documentation]