3PDT Wiring

All frequent questions on switching: true or not true bypass, transistor-based or mechanical.
Post Reply
User avatar
Muzzatron5000
Information
Posts: 18
Joined: 21 Apr 2021, 07:18
Has thanked: 5 times
Been thanked: 3 times

Post by Muzzatron5000 »

Hi all,
I am having some problems with a new 3DPT switch I have wired up.

I have a bit of NEWBY question....

Is there a correct way (top or bottom) the switch should be wired? I'm pretty confident I've followed my instructions correctly.
https://www.diyguitarpedals.com.au/shop ... rdrive.pdf

Looking at CODA effects here: https://www.coda-effects.com/2015/03/3p ... iring.html

It suggested there is a numbered sequence to the lugs and was wondering if I have wired it upside down?
I can't see any markings to show where the 'No. 1' lug is located or a top side etc..

:hmmm:
Top
User avatar
Intripped
Cap Cooler
Information
Posts: 665
Joined: 25 Aug 2009, 01:03
Location: Italy
Has thanked: 966 times
Been thanked: 305 times

Post by Intripped »

Hi,
there isn't any upside down, just be sure that the lugs are orizontal and not vertical.
Numbers are there just to simplify the wiring instructions (red wire to lug4 etc...)

Be careful while soldering on the switch, because it can't stand the heat for long: no more than a couple of secs per lug. If necessary, wait for the lug to cool down and then reflow the soldering.
Have a nice time,
Cheers
Top
User avatar
Muzzatron5000
Information
Posts: 18
Joined: 21 Apr 2021, 07:18
Has thanked: 5 times
Been thanked: 3 times

Post by Muzzatron5000 »

Great - thanks for your help. :-)
Top
Post Reply

Return to “Switching & Wiring”