Boss - PH-1r ( Phaser ) [schematic]
- candletears7
- Solder Soldier
If there was a layout and/or a pcb, it would most likely be in this thread.
Anyway, a have one on my bench for a mod.
It needs to be truebypass and a volume trim pot put in to bring the effect signal down in comparison to the bypass, as there is a noticeable volume jump.
I'm using Millenium bypass and a dpdt switch to fit in the flip flip hole, but I need to hardwire the circuit always on.
Reading this:
http://www.geofex.com/Article_Folders/bosstech.pdf
I need to remove sW3 and jumper the source and drains of sW1 and sW2.
Given the schematic and pcb shots given earlier in this thread, could someone help me identify those 3 FETS?
Thanks!
Anyway, a have one on my bench for a mod.
It needs to be truebypass and a volume trim pot put in to bring the effect signal down in comparison to the bypass, as there is a noticeable volume jump.
I'm using Millenium bypass and a dpdt switch to fit in the flip flip hole, but I need to hardwire the circuit always on.
Reading this:
http://www.geofex.com/Article_Folders/bosstech.pdf
I need to remove sW3 and jumper the source and drains of sW1 and sW2.
Given the schematic and pcb shots given earlier in this thread, could someone help me identify those 3 FETS?
Thanks!
- Dirk_Hendrik
- Old Solderhand
Information
There is no sw3 in this case.
Jumper the source drain connections of Q5 and Q6.
Jumper the source drain connections of Q5 and Q6.
- candletears7
- Solder Soldier
Brilliant. Thanks mate!
- candletears7
- Solder Soldier
all wired up with the trim and works great. I'll apply thinto another one I have to do, the hf2 hi band flanger. thanks again Dirk!
- modman
- a d m i n
Information
- Posts: 4890
- Joined: 19 Jun 2007, 16:57
- Has thanked: 4394 times
- Been thanked: 2131 times
Please, support freestompboxes.org on Patreon for just 1 pcb per year! Or donate directly through PayPal