Roland CH-60

Tube or solid-state, this section goes to eleven!
Post Reply
User avatar
frankus
Information
Posts: 13
Joined: 20 May 2009, 17:28
Completed builds: Fallclone SD-1, Keeley BD-2, Tonepad Big Muff, Tonepad Neoctavia, Modded Jen Wah, Tonepad Rosscomp, MXR Distortion+, Tremulus Lune
Location: Chelmsford UK.
Has thanked: 2 times

Post by frankus »

So I recently got a Roland CH-60 for a song on ebay.

Roland Cubes are a part of my past, I used to load my Dad's Orange Cube 40 into the back of our Brown Austin Allegro on gig nights. It was the first amp I used and I'm mostly a jazzer so it's clean and I like that :)

The CH-60 also packs the Boss CE-2 chorus or very near to it, which was my Dad's favourite pedal (back when he used them). It is concerning that that I'm posting tonight.
They've hard wired a very slow deep chorus on it 3k3 resistor + 100k resistor going from pin 1 of the 4558 instead of 10k + 100k linear pot.

I'm figuring I can replace the 100k resistor for a trimpot. I'm aiming for an almost leslie speed, I guess I could socket the resistors and experiment - does anyone have any advice ?

Post Reply