Is the mode switch 1, 2, 5 & 6 in the middle position, or 2, 3, 4 & 5?
Assuming conventional
1 4
2 5
3 6.
pin identification?
Lovetone - Meatball [traced]
- Nocentelli
- Tube Twister
Information
- Posts: 2222
- Joined: 09 Apr 2009, 07:06
- Location: Leeds, UK
- Has thanked: 1152 times
- Been thanked: 954 times
There are two types of DPDT on-on-on, the diagram uses type 1 (the most common version):
...so 1+2, 5+6modman wrote: ↑ Let's hope it's not a hit, because soldering up the same pedal everyday, is a sad life. It's that same ole devilish double bind again...
- Paul_5
- Breadboard Brother
OK. still dipping in and out of this project. All of my controls seem to be doing what they should - they change the sound and filter off frequencies that I would expect, but I don't have any sweep - the LEDs light up whenever they are triggered, so I'm assuming that the 1458 is doing what it should, but there isn't any sweep in either direction, almost like. fixed wah pedal. Any clue where I should look next?
The sounds in my head don't match the sounds from my amp, I guess that's why I'm here...