analogguru wrote:MoreCowbell wrote:analogguru wrote:MoreCowbell wrote:The plot thickens. The pedal sounds good with both a "82R" and a "820R" ...either works just fine - just changes the "perceived" output level on the volume knob.
I agree that it's a 82R in the Jennings you pictured AG (and certainly a 820R in the original photo)
the close-up picture showing the 820 ohm is NOT from an original unit, it was cloned by me (with a wrong value first).
more about that can be found in the link above.
MoreCowbell wrote:
Thanks for the pics soniciv and AG . I wish we could dig up more board photos of the actual Colorsound units.
For what ? I think, everything should be clear enough now.
analogguru
Ah, OK - I was under the impression that the board was from a production unit, NOT a clone built by you. It wasn't mentioned in the original post that it was a "clone", is housed in an original enclosure, and sits next to the original box, so that accounts for any confusion. The inference is easy to make that it's a production unit (given the enclosure, box, and lack of "clone" mention).
That happens when people violate copyrights and use a picture without referring to the source where it comes from:
http://www.stompboxes.co.uk/forum/viewt ... uzz#p26742
If you read this thread, I think it should be clear that it is a clone-pcb built by me. (BTW, the hole-distance on my circuit board is different to the original, I only have 1/10" hole-distance boards available).
analogguru
I can't help it that your original post leaves the impression that it is an original unit. Picturing it in the original enclosure, next to the original box leaves it "at best" amnbiguous, and in reality, makes people think it is original. Face it, if you saw someone picture a replacement PCB in an original enclosure, with the original box, and they didn't mention that the pcb was a "replacement" in that post, you'd have been all over them. I didn't bother to read the whole thread, as typically you don't post pictures of things you build and represent them as the original units, so I didn't see the need to "question" it. . I see where you later clarified that you built the pcb. No need to get all uptight - your original post wasn't "clear", that's all.
As far as me posting the picture, no need whatsoever to "refer to the photo source" as I simply quoted your original post in this thread . I didn't "repost" it from DAM. The "enlargement and altered pic" is debatable, but being that it is directly under the quoted post, it is easy to see where the original, unaltered photo came from.