freestompboxes.org

This is what I have made......so far

there is millenium bypas on board.........
truebypass and battery not shown on pictures......

Excellent as usual! Thanks a lot!

Thanks Peter.....

please can moderators erase last drawing....it is doubled by mistacke....

Boris

Is it possible for you to post a schematic for this Boris?.....

DrNomis wrote:Is it possible for you to post a schematic for this Boris?.....

Check this out : http://www.madbeanpedals.com/projects/index.html

Here's a schem for reference, although I haven't checked Boris' layout to see if the correspond exactly.

I have built madbean's deadringer. It was so good I sold my fulltone custom shop fulldrive 2 (the cream one, almost my last boutique pedal).
This is my favorite TS. The boost is a bonus!

boris i like your layout style. Curves are great.

I also like your enclosure. Is it etched?

...and I like those knobs! Where did you get them?
Great work as always bro!

boris i like your layout style. Curves are great.
I also like your enclosure. Is it etched?

....You are so kind....and yes it is etched

...and I like those knobs! Where did you get them?
Great work as always bro!

...thank you himister...so are you here to stey or you just dropped in by accident? ...knobs are supersecret

Here's a schem for reference, although I haven't checked
Boris' layout to see if the correspond exactly.

.......Thanks...I have checked....differences are (errors on my build)......

1...... resistor from base to V/2 of first transistor is 1M...should be 510k
2...... mosfet clipping section have no room for Ge diode( so cut trace and add it
3......most imprtant error is resistor 47K should not be connectedto pin 7 of the IC....so just pull it out from PCB and make wire connection to little SW

Boris

Where had you got the etching for the case done ? I've tried trophy places & engravers
but not much luck locally

Hi, folks. Does anyone have the correct schematic diagram of Fulldrive 2 mosfet pedal and you can send me on PM or e-mail?

Thanks a lot in advance!

Hi!

I'm having terrible difficulties making the three way on-on-on switch work for the comp cut/fm/vintage settings...what is the correct switch for the job?

Thank You!

I used this one: http://au.element14.com/multicomp/1md6t ... /155018501
Check the datasheet on that page for the pin configuration for each switch position.

Hay!
this looks nice! But i was wondering how does it sounds. has anybody compared it to the manufactured build????

KRALJSIMON wrote:Hay!
this looks nice! But i was wondering how does it sounds. has anybody compared it to the manufactured build????

I built one from aionelectronics.com/diy-pcb-projects/ (see his TS board) and i think it sounds pretty damn close to what I heard in the store with a real FD. I LOVE it!

..