freestompboxes.org

I've used the combo of VeeCad and TinyCad to do designs but since I only have the free version of VeeCad, the mono colors can get a bit confusing at times.

I really like DIYLC, but I can't figure out how to bring in a schematic and use that as the basis of my project. Is there a way to do this or do I just have to trace everything by hand?

I'm just looking for a way to make sure that my connections are right which gets difficult in more complex circuits without some kind of schematic integration.

bump, is this possible?

you can't do that with diylc. for pcb design, i would recommend eagle. it's got those functions, and it's free.

apparently veecad 2 has a autoroute function for veroboard anyone tried or got a keygen for it