Breadboarding a Fuzz Face . . where to start?

Ok, you got your soldering iron and nothing is going to hold you back, but you have no clue where to start or what to build. There were others before you with the same questions... read them first.
Post Reply
User avatar
Jederino
Information
Posts: 4
Joined: 04 Jun 2011, 20:04

Post by Jederino »

First time breadboarding a project, and was wondering where you guys start. I would think at the input, but was just looking to get some ideas. I'm just going to hook a 9v battery up for testing.

Thanks, and this is a great site, and I think this is my first post.

Much appreaciated.

Jed
Top
User avatar
CHEEZOR
Diode Debunker
Information
Posts: 830
Joined: 10 Jul 2009, 18:19
Location: California
Has thanked: 42 times
Been thanked: 47 times

Post by CHEEZOR »

It doesn't matter where you start, but I think a lot of people would start with the "biggest" part of a project, that is, the part with the most pins. In this case I would start with the 2 transistors, but I wouldn't worry about it too much. Just get it started! :)
Top
User avatar
teej212
Breadboard Brother
Information
Posts: 109
Joined: 03 Jun 2009, 00:24
Has thanked: 4 times
Been thanked: 8 times

Post by teej212 »

http://www.beavisaudio.com/bboard/proje ... Rev1_1.pdf

might be helpful
Top
Post Reply

Return to “Basic Knowledge”