Page 2 of 2
Re: Offer to make a single-sided PCB layout.
Posted: 26 Sep 2011, 01:39
by Duckman
Out esta al vesre
Re: Offer to make a single-sided PCB layout.
Posted: 26 Sep 2011, 01:44
by juanro
Hey, thanks for the extra couple of eyes.
You mean, the pin number? If so yes, I used a PCB component I made on the fly and didn't checked pin number with regards the schematic. While one pin is ground and the other IN or OUT, is good
Juanro
EDIT:
Ah y otra cosa: sos argentino, evidentemente? (Yorugua a lo sumo!) jeje.
Juanro
Re: Offer to make a single-sided PCB layout.
Posted: 26 Sep 2011, 01:52
by Duckman
Yeap, I'm talking 'bout pinout, but I know is a minor detail, ta?. Your skills in E-PCB are growing fast, congrats!
Re: Offer to make a single-sided PCB layout.
Posted: 26 Sep 2011, 02:43
by chinojapones
Juan
could do the Soldano SLO 100 preamp with the valves included in the circuit?
podrías hacer el pcb del pre del soldano Slo 100 con las válvulas incluidas en el circuito?
Ya tengo el del sloclone forum, pero querría con las válvulas y todo en un PCB
Gracias
Re: Offer to make a single-sided PCB layout.
Posted: 26 Sep 2011, 02:46
by chinojapones
Re: Offer to make a single-sided PCB layout.
Posted: 27 Sep 2011, 03:37
by juanro
I'm closing it by now.
I did the BMPlus, and perhaphs the Nobels ODR-1 (sounds like a circuit I would like to try)
The Soldano pre is out of the question for the time being, sorry.
Regards,
Juanro
