Page 1 of 1
D*A*M - FUZZ rong FR-69
Posted: 07 Dec 2011, 21:25
by beedotman
Hi!
Here's layout for
D*A*M - FUZZ rong FR-69.
Pot values are not confirmed
- especially 'Depth', but 250K should do the job. 100K or 500K should work fine, too.
If anybody can confirm exact value that would be great.
Enjoy!
Peace,
b
Re: D*A*M - FUZZ rong FR-69
Posted: 07 Dec 2011, 21:27
by beedotman
more guts
Re: D*A*M - FUZZ rong FR-69 [traced]
Posted: 07 Dec 2011, 21:28
by beedotman
and schematic that I used
Re: D*A*M - FUZZ rong FR-69
Posted: 07 Dec 2011, 21:41
by beedotman
Info about transistors gains and tone pot value:
Solidhex wrote: I've been messing with some old house numbered RCA's. Same package as the ones in the pics. The spec sheets on the originals state that q1 is usually around 120hfe and q2 around 65hfe. So far the best sound has been a 200hfe in q1 and 80hfe for q2 both with around 100 leakage.
Sticking lower gains in q1 sort of makes the sound dull. Less gain, less top end. The 22k resistor that goes from the .002 to ground (R6) is sort of annoying. It bleeds a fair amount of the q2 signal to ground. Probably to even out the volume of the two ends of the tone pot. I've seen schems calling for a 33k volume pot but that seems like it would hurt the output...probably go with the 500k.
Re: D*A*M - FUZZ rong FR-69
Posted: 07 Dec 2011, 21:41
by sinner
Great, thanks
Re: D*A*M - FUZZ rong FR-69
Posted: 07 Dec 2011, 21:43
by freq67
Just don't get the hype..............Build great pedals.....That's really cool but, the prices are just silly.
Re: D*A*M - FUZZ rong FR-69
Posted: 25 Mar 2012, 16:34
by beedotman
Another refreshed layout with full off-board wiring.
Re: D*A*M - FUZZ rong FR-69
Posted: 12 Aug 2012, 19:30
by beedotman
New layout for smaller vero
Re: D*A*M - FUZZ rong FR-69
Posted: 12 Aug 2012, 19:41
by sinner
My man!
Re: D*A*M - FUZZ rong FR-69
Posted: 12 Aug 2012, 19:51
by sinner
BTW - hard-on font