freestompboxes.org

Thought Id toss these up for everyone to use. If, like me, your breadboard layouts get far to cumbersome without pre-planning, or you perfboard builds go much faster if you plan them on paper rather than DIYLC or similar.

There is a column for bill of materials and a box for notes on each. I keep them in a 3 ring binder once if done one so I can always go back to it if needed.

http://www.randywebb.net/baconfat/Bread ... mplate.png

http://www.randywebb.net/baconfat/Perf- ... 0Board.png

Nice work. Hope you don't mind, but I'm also going to make copies of these for my students to use for labs/projects.

Zipslack wrote:Nice work. Hope you don't mind, but I'm also going to make copies of these for my students to use for labs/projects.

No problems at all. I shared it so it could be used!