MAX1044 causes of damage & alternatives

All frequent questions about ICs of all kinds, will be stored here.
Thaxt
Breadboard Brother
Posts: 67
Joined: 17 Jun 2008, 13:13
Has thanked: 1 time
Been thanked: 2 times

Post by Thaxt »



Yes - I've had MAXX's die on me as well...likely for a similiar reason: wallwart 9V supplies. I wonder if 9V batteries are culprits (as much) here?

Some 9V adapters put out a bit over the top as well..plus, maybe MAXXs aren't designed for wallwart levels (?) I've gauged my RS 9V filtered adapter (lg bodied) @ an actual 11-12 V when going into my breadboard supply!

I'd try this: put a 100 or so ohm resistor pre MAXX 1044 - that should bring the voltage down just a bit. Then you might derive a bipolar supply w'out killing the nice MAXX. I'd think 8.5 V wouldn't really harm your headroom/pedal fidelity - or would it?

@ any rate tho' I plan to upgrade as per the suggestion for the LT1054 & the TC______ unit.

Biploar supplies are a must when you get into Boscorelli-land.....or , you have some circuits on your custom PT that need more headroom ; phaser-vibe-complex modulation clones,etc

RnFR
Old Solderhand
Posts: 5138
Joined: 09 Jan 2008, 07:02
my favorite amplifier

Traynor YBA-III, Fender Super Six

Completed builds: custom fuzz.
Location: Inner Earth
Has thanked: 141 times
Been thanked: 137 times
Contact:

Post by RnFR »

i'm planning on running a MAX1044 for -18v supply, possibly 2 for switching to neg gr and doubling, but i'm not there yet. what has been decided on as far as diode protection goes? is it best to run it in series or parallel? and that is always cathode to + no matter if pos ground, correct?
"You've converted me to Cubic thinking. Where do I sign up for the newsletter? I need to learn more about how I can break free from ONEism Death Math." - Soulsonic

Blog-APOCALYPSE AUDIO

User avatar
kaycee
Solder Soldier
Posts: 162
Joined: 16 Mar 2008, 19:04
Has thanked: 28 times
Been thanked: 12 times

Post by kaycee »

I've used the ICL7660S on several of my own pedals frequently used at home and several that have gone out - both as polarity converters and as charge pumps and have not had any problems with mine or had any returns (touch wood). only issue was once ordering without the 'S' suffix, these introduce a whine to audio circuits.

Thaxt
Breadboard Brother
Posts: 67
Joined: 17 Jun 2008, 13:13
Has thanked: 1 time
Been thanked: 2 times

Post by Thaxt »

Yes - I have had significant problems w whine & noise w the MAXX1044 series.

jethrofloyd67
Posts: 14
Joined: 30 Apr 2013, 08:53
Has thanked: 1 time
Been thanked: 1 time

Post by jethrofloyd67 »

about to build a Supreux Deux from ROG, the mad bean Road Rage lists TC1044SCPA as well as MAX1044CPA and ICL7660SCPA.
of the 3 i cant seem to locate the ICL, so would the TC be the way to go?

Post Reply