Not sure if this is the proper place on the forum...but was hoping to get some technical insight. I am wanting to add the predelay section form the Ghost Echo to the Tenebrion reverb. See links with schematics below. looking at the Tenebrion schematic, Obviously the pt2399 will slide in right after c2 (cut trace to ic1 and leave trace to R11,) but I am not sure if any modifications should be made coming out of the pt2399 (pin 14, c3 r8 r9 on ghost schematic) and going back into IC1 on tenebrion. I'm building it with sockets between those two points and will experiment, but know some of you guys on here know what you're doing and aren't just a hack like myself.
viewtopic.php?f=7&t=8136&start=60
http://www.grindcustomsfx.com/forum/vie ... ?f=2&t=219