Page 1 of 1
Timmy Vero build wiring diagram
Posted: 04 Jun 2013, 05:04
by rydog0103
Hello:) Hey sorry if this has been asked and or a dumb question.... I just finished this guy.....
Can someone please tell me or show me the correct way to wire this up to a 3PDT foot switch, jacks, DC jack?? I have a couple wiring diagrams and not sure which one to use. This is my first vero build so I am lost! I'm so use to PCB's. Thanks so much for your help!!!!
Re: Timmy Vero build wiring diagram
Posted: 04 Jun 2013, 12:41
by Nocentelli
From the same website: The only minor differences are the blue output wire heading to the footswitch actually comes from the volume pot lug 2, not the circuit board itself as suggested here; Also, the LED current limiting resistor has been included on the timmy board, so you can leave it off the switching diagram, miss off the connection from +9v DC jack to the LED positive, and connect the LED positive to the "LED+" point on the timmy layout.
Re: Timmy Vero build wiring diagram
Posted: 04 Jun 2013, 15:44
by rydog0103
You rock!
Thanks you so very much!
Re: Timmy Vero build wiring diagram
Posted: 06 Dec 2013, 03:58
by Nate77
So.... Not to beat a dead horse here, but the negative side of the LED still is connected to the footswitch? I assume that's correct but half of my assumptions have gotten me into a fair amount of trouble.....
Thank you for the awesome, consise and verified layouts and instructions as well as advice. Not sure what is do without this site!
Re: Timmy Vero build wiring diagram
Posted: 06 Dec 2013, 05:33
by Nocentelli
Yes.
