freestompboxes.org

I'd like to make a simple passive "Y" splitter to feed two amps even if the amplifiers have large "ground" voltage differences. The "BigShot ABY" appears to do that but I can't find the model of the transformer used in the circuit and I don't need the A-B selection ability.

Attached is the block diagram for the BigShot. Can anyone suggest an appropriate make/model transformer?

PS - also attached is the spec sheet for the OEM transformer.

Those things are like $50. You're not going to save nearly enough money to even justify the time spent sourcing that transformer.

The Lehle LTHZ is perfect, but expensive.
It's used in the P-Split, maybe you should buy that used. It's the sturdiest pedal that I've ever had.

look for Edcor transformers
good prices ...but only if you're in the USA

Thanks. Do you think this Edcor model would do the trick? http://www.edcorusa.com/p/143/wsm600-600http://www.edcorusa.com/p/143/wsm600-600

WSM600/600
1/2W 600 Ohms to 600 Ohms (1:1) line level matching transformer.

...i don't know
you could write and ask directly in the forum on edcorusa.com (and let us all know the answer!)

Got a response from EDCOR. They recommend:
WSM6400
1/2W stereo unbalanced line level signal to a mono unbalanced or balanced line level signal
$10.23 each.
http://edcorusa.com/p/220/wsm6400