freestompboxes.org

Hey guys,

Had some requests regarding on how to make PCB footprints in EAGLE for tube sockets. Please excuse the sound quality (i will redo it ASAP).
Also the package that you are building for eagle (the lib file) can be imported in DIP Trace.



Hope you will find it useful and please don't hesitate to post your comments.

Best regards,
Gabriel

Thanks

If only usable Eagle package wouldn't cost like a family car...

I'm quite sure I've done this for diptrace

Edit: moved to the Software Room

Indeed is a little bit expensive but is not a bad software .

PS: sorry for posting in the wrong section

A little bit? Man, I could build a house for less

Good job. Thanks for your effort