good day guys.
Im planning to make a Precision drive clone with built in Noise gate and I found this Zvex Box of Metal's Noise Gate and I'am planning to use this in Precision drive. my question is, if I use 18volts in the circuit, will the higher voltage affects the performance noise gate? or I should put a 9 volts zener diode as a regulator?
Box of Metal Noise Gate to Precision Drive
- Manfred
- Tube Twister
Information
- Posts: 1945
- Joined: 04 Apr 2009, 23:42
- Has thanked: 1675 times
- Been thanked: 1360 times
At an operating voltage of 18V the circuitry of the noise gate stage must be adapted for this voltage.
The connections of VR4 pin 1 and 3 to the circuit are missing.
The connections of VR4 pin 1 and 3 to the circuit are missing.
- jhergonz
- Breadboard Brother
I think I need to make the Noise gate's voltage be regulated.Manfred wrote:At an operating voltage of 18V the circuitry of the noise gate stage must be adapted for this voltage.
The connections of VR4 pin 1 and 3 to the circuit are missing.
the Vr4 is the treble control of the Box of metal.