Q.A. Rice, A Simple Compressor, Practical Electronics, February 1977 🇬🇧

Post by **modman** » 13 Dec 2021, 09:51

Practical-Electronics-1977-02-OCR-Page-0063 simple Compressor.pdf: (47.25 KiB) Downloaded 130 times

Ben N · Post by **Ben N** » 13 Dec 2021, 16:59

"Relatively insensitive pickups" were once my calling card, but that was a long time ago...

ppluis0 · Post by **ppluis0** » 14 Dec 2021, 00:52

IMHO, a small value resistor placed in series with the led would be good

Manfred · Post by **Manfred** » 16 Dec 2021, 19:07

I made this board layout considering the optinal series resistor before the LED as suggested by Ppluis0.
TR1 to TR3 could be BC548.

Ready-to-print PDF-files:

PE Simple Compessor PCB Component Side.pdf: (11.02 KiB) Downloaded 74 times

PE Simple Compessor PCB Solder Side.pdf: (2.71 KiB) Downloaded 71 times

Sprint-Layout6.0-file:

PE Simple Compressor.zip: (10.89 KiB) Downloaded 70 times

Manfred · Post by **Manfred** » 18 Dec 2021, 11:28

Board size: 1.7" x 1.1" , 43 x 28 mm

: PE Simple Compressor 1 Vero.jpg (62.22 KiB) Viewed 977 times

: PE Simple Compessor 2 Vero.jpg (63.26 KiB) Viewed 866 times

PE Simple Compressor Componet Designators.pdf: (213.82 KiB) Downloaded 69 times

PE Simple Compessor Component Values.pdf: (215.46 KiB) Downloaded 66 times

PE Simple Cut Pattern.pdf: (60.23 KiB) Downloaded 63 times

LochMaster 4.0 - file:

PE Simple Compressor Vero.zip: (262.31 KiB) Downloaded 64 times

bmxguitarsbmx · Post by **bmxguitarsbmx** » 18 Dec 2021, 17:14

I'd be tempted to take my output off the collector of TR2 for all that gain and distortion

ppluis0 · Post by **ppluis0** » 19 Dec 2021, 02:21

Hi Manfred,

According the schematic of a similar compressor posted at this link: viewtopic.php?t=31743 we can be sure that R7 value will be 470 ohms

Cheers,
Jose

Manfred · Post by **Manfred** » 19 Dec 2021, 09:33

ppluis0 wrote: ↑19 Dec 2021, 02:21 Hi Manfred,

According the schematic of a similar compressor posted at this link: viewtopic.php?t=31743 we can be sure that R7 value will be 470 ohms

Cheers,
Jose

Hi Jose,
thanks for keeping an eye on it.
I did edit all the attached documents in my two posts above.

Cheers,
Manfred

Jarno · Post by **Jarno** » 23 Dec 2021, 11:18

ppluis0 wrote: ↑14 Dec 2021, 00:52 IMHO, a small value resistor placed in series with the led would be good

Yes, but without it the LED goes Super Hard On