Boss DD-2 no power; keeps blowing D-6
- Beedoola
- Resistor Ronker
I bought some 12v 1W diodes. I've repaired these in the past where this was the issue and is in the repair notes linked below as a common symptom of the no power issue.
I replace the diode and I get no power and the PCB at D-6 gets extremely hot. I had to remove part of the trace as it came up.
Anyone have any other thoughts on how to troubleshoot this? Below is the schematic and link to a BossArea thread:
http://www.bossareaforum.com/Forum/view ... p?f=6&t=17
https://www.hobby-hour.com/electronics/s/dd2-delay.php
I replace the diode and I get no power and the PCB at D-6 gets extremely hot. I had to remove part of the trace as it came up.
Anyone have any other thoughts on how to troubleshoot this? Below is the schematic and link to a BossArea thread:
http://www.bossareaforum.com/Forum/view ... p?f=6&t=17
https://www.hobby-hour.com/electronics/s/dd2-delay.php
Last edited by Beedoola on 30 Apr 2022, 02:28, edited 1 time in total.
- Manfred
- Tube Twister
Information
- Posts: 1937
- Joined: 04 Apr 2009, 23:42
- Has thanked: 1671 times
- Been thanked: 1344 times
Either the D-6 is installed with the wrong polarity or the power supply is feeding more than 11VDC.
- bajaman
- Old Solderhand
Information
- Posts: 4549
- Joined: 26 Jun 2007, 21:18
- Location: New Brighton, Christchurch, NZ
- Has thanked: 595 times
- Been thanked: 2058 times
check the 7805 regulator
be kind to all animals - especially human beings