freestompboxes.org

Reachahighernoon wrote: ↑01 Jul 2022, 04:00
Lol, though channel 3/4 switch seems like a good idea

And my board works too, though it's channel 4, insane levels of gain and compression though again I did not include the post tonestack cathode follower

I am going to try the Post Tone Stack stages... more tubes look cooler.... and you tone, the way it looks effects the tone...


Also, I have an 6V6 power section amp that the preamp is 4 gain stages, no Cathode follower before the tone stack... it is a gain beast

Any progress on this? I have a request for something similar, 50 watt amp though.

I was wondering if there was a drawing for the dropping string. Maybe the power tube plate tube voltages would be enough of a clue to get the preamp up to 400v.

dorrisant wrote: ↑13 Jun 2023, 04:49 Any progress on this? I have a request for something similar, 50 watt amp though.

I was wondering if there was a drawing for the dropping string. Maybe the power tube plate tube voltages would be enough of a clue to get the preamp up to 400v.

Hey dude,

I have the board made up and populated. I have been traveling a lot for work so I haven't had a chance to move forward on it