freestompboxes.org

tracing pedals since 2007
https://www.freestompboxes.org/

Charles Blakey, Solid State Reverb Unit, Electronics Today International, April 1980 🇦🇺

https://www.freestompboxes.org/viewtopic.php?t=32141

Page 1 of 1

Charles Blakey, Solid State Reverb Unit, Electronics Today International, April 1980 🇦🇺

Posted: 09 Jul 2022, 12:28
by modman
PDF
80-17_ETI.pdf
(1.17 MiB) Downloaded 112 times
80-17_ETI SS reverb 1.jpg
80-17_ETI SS reverb 02.jpg
80-17_ETI SS reverb 3.jpg
80-17_ETI SS reverb 4.jpg
80-17_ETI SS reverb 05.jpg

Re: Charles Blakey, Solid State Reverb Unit, Electronics Today International, April 1980

Posted: 09 Jul 2022, 16:06
by OC26
The way R33 is connected is wrong. Remove connection to pin 8 IC1c (output mixer) if you want the circuit work. Just in case you can find the MN3011 chip... ;-)

Re: Charles Blakey, Solid State Reverb Unit, Electronics Today International, April 1980

Posted: 10 Oct 2022, 21:27
by wernersaurus
Mistake in the drawing - circuit board is OK
Capture.JPG
Capture.JPG (21.97 KiB) Viewed 272 times
All times are UTC
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited