Baja Sagittarian - switch pop [SOLVED]
- DjPsychic
- Breadboard Brother
Hey all,
I've got an older Baja Sagittarian made by "Mojo Pedals" that has a pretty bad switch pop. Would soldering a pull down resistor between the switch and PCB input wire work?
Thanks
I've got an older Baja Sagittarian made by "Mojo Pedals" that has a pretty bad switch pop. Would soldering a pull down resistor between the switch and PCB input wire work?
Thanks
- Manfred
- Tube Twister
Information
- Posts: 1937
- Joined: 04 Apr 2009, 23:42
- Has thanked: 1672 times
- Been thanked: 1344 times
To test, unsolder the wire from the switch terminal to the LED cathode to see if the pop is coming from the LED.
- Intripped
- Cap Cooler
It works, but in this way the 1M resistor is always connected to guitar signal, even in bypass.
You should put that resistor directly on the PCB, across the IN pad and ground.
Or, on the 3pdt switch, across the pin connected to IN of PCB, and ground (pay attention, 3pdts are quite delicate and you don't want to apply too much heat on the pins. The risk of melting is high)