freestompboxes.org

I don't know who put this on-line, but here's

Hello everyone, Baja great job with this pedal sounds amazing and is the DIY pedal sounds more real . Someone will have this pedal wiring and can share .
Best regards

Hallo. Could someone please, upload pdf again? I am also interested in Stations additions, in case theres some scheme or instructions for that. Thanks a lot.

I am currently reviewing this project and have incorporated a lot of the mods mentioned. I have also completely redesigned the printed circuit board layout and it is presently being fabricated - spare boards will be available - PM me for details if interested. I am also working on redrawing the new schematic, but this may take a few days to appear. in the meantime, here are some pictures of how the new board is looking.
cheers
bajaman

Great Job, Bajaman!!

...and it would be an even greater job, if you could sell the pcb in germany, Uwe!

...and it would be an even greater job, if you could sell the pcb in germany, Uwe!

I can sell you one of my pcb, but at this stage it is unverified to work until i have actually built and troubleshooted it. If you want to give it a go unverified, then PM me for further details.
cheers
bajaman

Great rotary. I liked it for guitar better than in my CX3 though.
Edit... I said that 5+ yrs ago already

Building it - the new layout, is on the to do list for this coming week (assuming i am not too busy trying to make a dollar - lol)
cheers
bajaman

Hi everyone
this is my way of seeing the bajaman layout but it does not work. could someone give me a hand to make it work? I used is a mn3007 and powered at 12vac, what should I replace to make it work? I repeat I followed the layout of bajaman a page 1. Please help me

We do not know. There is no fixed recipe for what to replace. Start of by check if all DC supply voltages are available.

......also use a 16vAC adaptor NOT 12vAC

the tensions arrive right on the effect, but you feel little, I do not know where I was wrong, I followed everything coem you said you bajaman.do I post a picture of the pcb made with all the components installed?

bajaman wrote:I am currently reviewing this project and have incorporated a lot of the mods mentioned. I have also completely redesigned the printed circuit board layout and it is presently being fabricated - spare boards will be available - PM me for details if interested. I am also working on redrawing the new schematic, but this may take a few days to appear. in the meantime, here are some pictures of how the new board is looking.
cheers
bajaman

top s.JPG

bottom s.JPG

this file as I understand is made with gerber? would you have a layout for this? or gerber files to make the pcb? I would be grateful

bajaman wrote: ↑10 Sep 2017, 21:38 I am also working on redrawing the new schematic,

Hi bajaman,
any chance for a redrawn schematic?

T.

I have a question to CX-3 users/builders. I've finished one recently, with MN3007 instead of the MN3004. It works, but I'm not sure about one thing.. It's noticeable only on fast setting - modulation effect speeds up, slows down.. but there's this one brief moment like it was going to stop.. it's hard to explain.
Here's the sample. https://www.dropbox.com/s/q59u9mzoj5j6thw/cx3.mp3 (alternative link, to wav format https://www.dropbox.com/s/fhcjomrezboxeqk/cx3.wav)
Slow setting first, then fast.

Schematics available?

On top of this page...

Any updates on this? I PM'd bajaman but he's not answering