freestompboxes.org

Hi folks
I was recently asked for fab house files for some of these boosters and realised I did not have anything to offer because the original artwork was done in CorelDraw and not a recognised PCB artwork package. I spent a few hours with the excellent Sprint Layout 6.0 ( if you are not familiar with this program I strongly suggest you check it out ), and now i am happy to post some images for the smd files for the DG20, SPC,and RPC boards as well as through hole versions for SPC and RPC. Most fab houses require gerber files, and these are listed below. I am happy to supply the Sprint Layout 6.0 files upon request - just PM me if you need them. In the meantime here are some gif images and gerber files exported from the Sprint Layout 6.0 files. Kindest regards to all and hope you are getting through this awful seemingly neverending covid pandemic safely
cheers bajaman

Here are a few more ....

Hello guys!! Ive stumbled on this Forum post searching for an solution for a problem with the new DG20.
I want to make my "ULTIMATE" Partcaster with the new DG20 but I plan to replace the switch with 10-Way Freeway Blade Switch...
My problem with it is that the new DG20 has the PCB mounted and i am not that knowledgable in electronics as the EMG instruction specifies that EMG pickups dont need the Groundwiring and the Freeway Switch Wiring diagram has contacts for ground and hot... If its not possible via DG20 PCB, i am willing to buy the pickups and exg and spc separately to do that modification.
I just need your assistance on this matter as you guys are much smarter than me

Hi,

what type of potentiometer is designed for? Bourns, Cts, Alpha... ? As well the first design smd version ( buffered ) in the page 1.

Hello! Could anyone please share the schem for the RPC? I see the pcb layouts but can't find the schematic for it

Hello, what is the correct installation order for SPC, RPC and EXG?
1-RPC-SPC-EXG-OUT, or
2-RPC-EXG-SPC-OUT