freestompboxes.org

I have Timmy PCBs. They use a 3 position (on/off/on) SPDT switch instead of the internal DIP switches.
Layout: http://imgur.com/KNL46.gif
Fits in a 1590B.

Has some extra room in the clipping section if you want to experiment.

$8 USD each with free shipping.
Yes, I'll ship them to the US, UK, Europe, Japan, Australia, pretty much anywhere.
PM me or, if you prefer, use http://boardshop.weebly.com/.

PM'd

Is those the same I got from you last time?

BTW - quality of your PCB's are top of the tops!!!

sinner wrote:Is those the same I got from you last time?

BTW - quality of your PCB's are top of the tops!!!

Yup.
And thanks.

They are great!
Thanks

Bought one from the store!

All gone.

Hi, I've asked you a question via PM, but it was ignored by you, so again witch pads are for switch, and witch are for treble pot?, also what kind of toggle I should use?

Cheers
Pawel

Just use a SPST mate, the connections are marked on the layout, 1 2 and 3 directly below "Switch" on the layout.

Thanks You're my princes so Treble takes only pad 1&2?

Treble 2 and 3 are linked

Pawel I just realised I wrote SPST, but it obviously needs the changeover type with 3 lugs, SPDT. That'll teach me to post with my brain out of gear.

ahhh, missed out... you didn't happen to order more than one did you IvIark?

Of course, I never only order one of something!

IvIark wrote:Of course, I never only order one of something!

do you fancy selling me one then!?

are these verified to the schem
http://3.bp.blogspot.com/_y4AYtND8Hz8/S ... am2ed5.png

just that I don't see the 3K3 going to pin 2 of the drive pot is all.. my schem kung fu is weak though.
or is that schem wrong?

and the switched diodes seem different too?
the schem shows only 6 X 1n4248 in total, but there's 7 here...

any chances for another run?

thanks
a

I have a partially populated one, if you're interested.

i'm interested. anyone have any spares?